Posts on this page of our Blog relate to products and information from PHILTEC.
For more information about our suppliers and their products, please contact us.
Philtec recently performed calibration tests on their sensors, using different target materials supplied by their customers. Calibrations were made to 4 different metal targets without adjusting the gain output control. Only the SNR control was varied to 3-4 volts max to optimize the signal for each target. The four targets were: Dull Metal: A dull … Continue reading
Philtec produces threaded tips in a variety of lengths and sizes. Some are easy to machine, while others are very difficult. Any diameter thread with a long length is more difficult. Read Philtec Application Note No. 73 to see Philtec’s Table of Standard Minimum Thread Sizes for Sensor Tips. This table shows standard threads with standard lengths … Continue reading
Philtec standard sensor tips are constructed with glass fibers and stainless steel housings. Materials available for more extreme temperature ranges include high temperature epoxy, high temperature adhesive, mechanically bonded fibers, or fused-end quartz fiber. These materials provide different ranges of operation up to 800 °C. (See Philtec Application Note No. 71.) In addition, fiberoptic cable … Continue reading
Many of Philtec’s customers need casings for fiber optic probes and cables that are exposed to high magnetic fields. Philtec’s answer is to jacket the cables in non-metallic materials and also to construct the sensor tips from non-metallic or non-magnetic materials. These sensors can therefore be configured to perform measurements in environments where very high … Continue reading
The standard polyvinyl chloride (PVC) jacket over a flat steel ribbon monocoil is the standard cable jacket provided by PHILTEC. This jacket is good for general purposes. It features moderate crush resistance and moderate tensile strength. The recommended temperature range is between 10 and 105 °C. Additionally PHILTEC provides alternatives to this model, specifically designed … Continue reading
PHILTEC recently received the following testimonial from one of their customers: “We are pleased to inform you that recently the Surface Technologies Research Group from Mondragon University published a research article called ‘On the Role of Contact and System Stiffness in the Measurement of Principal Variables in Fretting Wear Testing‘ featuring an RC90 sensor from … Continue reading